Composite Sight Mounting Plate for RMSC sized sights on the TX22 Competition

So, I bought a micro red dot for my TX22 Comp to reaslizing there was no factory way to mount it properly. I originaly rigged it but didn't feel good about the install. Came acrosxs this gem. It worked perfectly. It does seem to be 3d printed, but durable. It fits great and the design on the bottom of the hex nuts holding the screws in was bnrilliant. This should hold up nicely and was the perfect solution to my $200 mistake. All is well for a $20.0 0 fix. Thank you Lakeline!

I was real excited about this. Shipping was quick. Upon receipt, I quickly noticed the lack of recoil lugs - the main difference in optic footprints and the reason adapter plates are made. I should have looked closer at the picture. Well I have it now and mounted it. Haven’t shot the TX since putting it on, but will see if it loosens over the next few range visits. If it holds fast, then I’ll mount the optic and see if it stays in place. If over the course of a few range trips it holds, I’ll change my rating. The “composite” material is a lot softer than I expected. It’s not a laminated composite, so I’d say it’s a hard plastic. We’ll see. Time will tell.

Nice clean fit on TX22 Comp for the smaller RDS like Romeo Zero and accommodates shroud. Do not over torque while securing this plate to barrel. The plastic material is soft. Recommend not to exceed 15 in/lbs.

The Reflex Sight adapters that came with the TX22 Competition Conversion Kit did not accommodate the Holosun 507K. LAKELINE in for the save. Perfect fit.

I was a little skeptical about this being plastic but the plastic is a very high quality. It fits the pistol well and looks better in my opinion.