Striker Guide and Slide Plate to fit the Taurus GX4, GX4XL, and GX4 Carry.
Includes a stainless steel striker guide, reinforced nylon slide plate, and 3-48 x 3/16 inch set screw. A 0.050 inch hex wrench is needed for assembly.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
9 Reviews Hide Reviews Show Reviews
-
Striker guide
Great replacement for the plastic
-
Striker guide
Very well made product and seams to speed up ignition.
-
Good
It was perfect
-
Striker guide
Everything fit perfect.
-
Striker guide and plate
This striker guide was a direct fit to my gx4, and what a major upgrade, beautiful stainless striker guide that replaced the cheap plastic original, great job Lakeline!!!
-
Excellent quality
Highly recommend
-
Striker guide
Nice product much better than stock striker guide
-
Trigger pull
The stainless steal Striker guild makes the trigger pull very smooth on my GX4. I didn’t need the back plate. I just used my factory plate. Lakeline: It is highly recommended to use the Lakeline provided back plate with a set screw that locks it in position. The added mass of the stainless steel striker guide can cause the factory back plate to walk out of position. SMH...
-
A Must Have... for a smoother trigger pull.
If you want to have a smoother trigger pull, and zero worry your stock plastic striker guide is going to crack, or break this SS Striker Guide is for you. However, I did not like the 3D printed slide plate too much, it did not pair with the higher end SS striker guide. In my opinion pair the striker guide with the SS slide plate also for sale by Lakeline for a few more $$.
