Single-Piece (only 1 required per pistol) Stainless Steel Striker Spring Retainer for Taurus G2/Millennium series. Replaces part 20, Firing Pin Spring Sleeve in the Taurus G2C manual.
Fits all versions of the GX4 (including GX4XL and Carry), G3 (including the G3X and G3XL) , G3C (9mm and .40cal), G2C, PT111 G2, GX2, GX4 (all models), 709 and 740. The factory part is easy to send flying and can be hard to find.
The one-piece design makes removal and installation a breeze!
Machined from stainless steel.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Lakeline Lifetime Limited Warranty
51 Reviews Hide Reviews Show Reviews
-
Awesome product
N/A
-
Spring retainer
Don’t think it has any performance upgrades. But it make’s reassembly a breeze. Less likely to loose one of the factory retainers or a spring.
-
Striker Spring Retainer
Replaced the plastic two piece retainer as I was replacing the Striker Guide. Nicely machined piece an upgrade from plastic. Fit perfectly, easy to install.
-
Spring retainer
Made disassembly and reassembly so much better. Should have came this way from factory.
-
Spring retainer
Perfect with the guide. The machining is phenomenal. Dont think twice, order it!!
-
Striker spring retainer
This retainer is a lot better then the stock one.It is easier to put on and off.
-
Perfect!
I bought two for 2 Taurus G3C and they fit perfect.
-
S.S. firing pin retainer
Perfect fit, No hassle install.
-
Change plastic parts
The part fit perfectly on my Taurus G3C.
