Filler Sleeve to use the 17 round 9mm Taurus G3 magazine in the Taurus G2C or G3C

(2 customer reviews)

$12.99

In stock

Description

Ergonomic and sturdy, this high quality fill plate looks great and is sturdy.  Printed on Mark Forged 3D printers for the best possible strength and appearance.

Sold in the Continental U.S., Alaska, Hawaii, and Puerto Rico only.

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Additional information

Weight 2.0 oz
Dimensions 7 × 1 × 5 in

2 reviews for Filler Sleeve to use the 17 round 9mm Taurus G3 magazine in the Taurus G2C or G3C

  1. mcclaxt21

    Just what I was looking for, great fit with the 17rd G3 mag in my PT111 G2. Will be ordering a couple more.

  2. Nicholas Willcox (verified owner)

    They fit, but they are a tiny tiny tiny bit too big and slide off the magazine. For holsters/mag pouches it means that the insert will slide down and when you grab the magazine you have to adjust the insert first, then insert the magazine and go. I don’t have digital calipers to get a reading but it’s a tiny little amount and you could probably throw a piece of paper folded over in there to stop the sliding.

    Aside from that – thankful for these. They add a good grip for the bottom of your firearm, they look good, and of course any shopping with Lakeline LLC is a confident purchase.

    Recommend? Yes
    Will buy again? Yes
    Suggestions? Tiny bit smaller to get a snug fit against the magazine.

Add a review