Ergonomic and sturdy, this high quality pinky extension looks great and is sturdy. Printed on Mark Forged 3D printers for the best possible strength and appearance.
Get the same grip size and support as using the 13 round magazine with your 10 round magazine for capacity limited states.
Its snug fit into the frame eliminates the potential for pinching in our testing.
Does not fit the Hellcat Pro. A similar part is available for the Hellcat Pro 15 round magazine.
Pistol and magazine shown for illustration only. Only the plastic pinky extension is included.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
12 Reviews Hide Reviews Show Reviews
-
A must have if you have big hands.
I live in a 10rd capacity state, when I purchased my Hellcat it came w/a pinned 13rd mag & one 10rd mag w/pinky extension that is okay but not enough for a solid grip. These extensions were a lot easier to install than I thought. Literally snapped them on in about 15-30 seconds each. They make gripping & drawing out of the holster a lot smoother. From time of this review, I ran about 600+ rds with them. No feeding or ejecting faults. A must have if you have big hands.
-
Like factory
If there is one thing I love, it something that feels like it belongs on a firearm. I was skeptical at first that these would feel like the grip on the firearm and I commend them for this. Feels just like the factory (or pretty damn close) texture as you would get on a Springfield pinky grip. The added length without adding rounds to a 10rd mag is great!
-
10 Round extension
Fits nicely, gives a better feel for hand hold. Defiantly recommended addition if gun feels a little to small for hand. I found I needed to hold spring down while installing.
